Table of Contents
What setting should I use on my Scotts spreader overseeding?
For application using a pushed broadcast spreader, Scotts recommends a setting of 5 1/2 when overseeding and a bare-lawn setting of 8 1/4. With a handheld broadcast spreader, Scotts recommends a setting of 4 when overseeding or seeding a new lawn but suggests that the sower make two perpendicular passes for new areas.
What setting do I put my fertilizer spreader on?
Set your spreader so that it’s ¾ open when engaged. If, for example, the spreader is calibrated 1 to 20, set it at 15. Place eight pounds of Milorganite into the spreader’s hopper. This is about one-fifth bag, or 8 lbs., of Milorganite, which is equivalent to 24 cups.
What setting should I use for Lesco grass seed?
Set the spreader to the lowest setting at which the seed flows evenly from the spreader, and make passes over the entire lawn in one direction, say North/South. Hopefully, you will have used far less than half of the seed. Then, make passes over the entire lawn in the other direction, say East/West.
What is the Lesco® spreader setting for Scott’s edgeguard DLX?
Cross reference this setting over to your spreader EXAMPLE: Dimension .10% 19-0-6 has a LESCO® spreader setting of 15. Cross referencing it over to a Scott’s EdgeGuard DLX would be a spreader setting of 6 (see below).
How do you use the Scotts Turf Builder edgeguard DLX?
Use the Scotts Turf Builder EdgeGuard DLX Broadcast Spreader to apply grass seed and fertilizer in spring, summer or fall. The large hopper holds up to 15,000 sq. ft. of Scotts Lawn Care Products and is delivered ready to use and pre-calibrated; no assembly required
Where can I find spreader settings for Scotts® products?
Spreader settings can be found on the “Details & Usage” tab for that product. Or, visit the spreader settings tool. Spreader settings for Scotts® lawn food can be found on product packages and the product information pages. Click here for the Scotts® Turf Builder® Lawn Food product page.
How do I use a Lesco spreader?
When using a LESCO product, find the designated setting listed on the bag and then cross reference that number to your particular spreader type using the attached documents. Keep in mind that labeled settings on the product bag and those listed within the charts are approximate and should be used as a starting point only.