How do you reset the anti theft on a 2002 Ford Explorer?

How do you reset the anti theft on a 2002 Ford Explorer?

First, go to the driver’s side of Your vehicle, and insert the key into the lock. Turn the lock to the right, or to the unlock position. Hold this position and count for 25 to 40 seconds. Doing this will bypass the anti-theft system.

How do I get my Ford Explorer out of anti theft mode?

Key

1. Insert the key into the driver’s side door lock.
2. Turn the key once, but not all the way to unlock the door. Leave the key in this position for 40-60 seconds.
3. Do this again, but turn the key in the opposite direction.
4. Remove the key from the door, get into your Ford, and start the engine. The system should be reset.

How do I get my car out of anti theft mode?

Step 1: Insert the key into the door lock. Use the side door on the driver’s side and the physical key even if there is a keyless entry system on the car. Step 2: Turn the vehicle key to unlock the car door without releasing it. Hold the key for 30 seconds in the position.

Where is the valet switch on a 2002 Ford Explorer?

The valet/override switch is a small button under the dash near your knee. This button is either very small and spring-loaded, in which case it will be red or black, or it will be larger and flippable. Press or flip the switch.

How do you turn off the anti-theft system on a 2000 Ford Explorer?

Allow the driver’s door to be locked for at least 30 seconds, then use the key in the door cylinder to unlock it. This should clear anything that is wrong with the alarm system.

Does a 2002 Ford Explorer have a chip in the key?

The key contains a tiny embedded electronic chip called a transponder.

How do I get my 2002 Ford Ranger out of theft mode?

Resetting Your Anti-Theft System

1. Put the key in the ignition.
2. Turn it to the on position, but don’t start the engine.
3. Turn it back off again.
4. Repeat this process eight times, leaving your key on with the final turn.

Will disconnecting battery reset anti theft?

It is another way to solve the problem of anti theft system car wont start. Disconnect the positive terminal of the battery for a minute or two. It will reset the computer system and your car is likely to kick off.

Is there a fuse for the anti theft system?

It is usually located on the dashboard by the driver’s door, in front of your left knee. You may find the alarm fuse in this fuse box. If you do not find an alarm fuse inside of the car, look in the fuse box under the hood on the driver’s side. Your car model may or may not have additional fuse boxes.

Where is the valet override?

Typical locations for valet switch: Under the driver’s side dash (mounted in the under-dash covering trim panel or wire-tied to a harness) Mounted in the driver’s side kick panel. Mounted in the steering column plastic housing.

How do you turn off the alarm on a 2002 Ford Explorer?

To reset the alarm on the Ford Explorer You have two options. You can pop the hood and disconnect the positive battery cable, then leave it off for about 30 minutes. This will make the power in the CPU drain, which will force the system to reset itself the next time it comes on.

How do you reset the security system on a 2000 Ford Expedition?

Turn the ignition on and off three times, on the third turn leave the ignition running. Press and release the brake pedal, and then turn the ignition off. Repeat these steps again for a second time. After the second time a horn should go off letting the driver know that the sensor has been reset.

How to reset the anti-theft system on a Ford?

Now try to start the engine. The car’s engine should start as you have successfully reset the anti-theft system of your Ford. Repeat the process at least a couple of times if it does not work the first time. This method uses the door lock of your Ford to reset the system. Insert the key into the door lock, on the driver’s side door.

How do I Reset my anti theft light on?

Options Some anti-theft lights blink by default (a small red light near the dash, for example is there to warn off thieves). If this is some other type of light then disconnect your battery (negative first then positive) for 30 minutes and reconnect in reverse order (positive then negative). This should reset the computer.

Why is my anti-theft light blinking?

Some anti-theft lights blink by default ( a small red light near the dash, for example is there to warn off thieves ). If this is some other type of light then disconnect your battery (negative first then positive) for 30 minutes and reconnect in reverse order (positive then negative).

Where can I get a replacement Ford anti theft key?

Oh boy, your at the mercy of your local Friendly Ford Dealer. As far as I know, they’re the only one who can reprogram the anti theft system and cut you the proper key. Get two keys. Home Depot and Sears can cut you a duplicate for less then FORD.