Table of Contents
- 1 Where is the camshaft position sensor located?
- 2 Where is the camshaft sensor and the crankshaft sensor located?
- 3 What happens when the camshaft position sensor goes bad?
- 4 Where is the crank sensor located on a Dodge Stratus?
- 5 Is the crankshaft position sensor the same as the camshaft position sensor?
- 6 What is code P0017?
Where is the camshaft position sensor located?
Camshaft Sensor Locations The camshaft sensor is usually located near the top of the engine. It might be on the top of the block, on one or both heads, or on the intake manifold, usually near the timing cover. In some cases, you might find the camshaft sensor behind the timing cover.
What is the 7 symptoms of a bad camshaft position sensor?
If your vehicle idles roughly, stalls frequently, has a drop in engine power, stumbles frequently, has reduced gas mileage, or accelerates slowly, these are all signs your camshaft position sensor could be failing.
Where is the camshaft sensor and the crankshaft sensor located?
The Camshaft Position sensor is typically located in the cylinder head of the engine and has a cylindrical portion that inserts into the head. The Crankshaft Position sensor is normally located in the timing cover or on the side of the block with a cylindrical portion that inserts into the block.
Where is the camshaft position sensor on a 2004 Chevy Colorado?
Look on the driver side of the engine near the firewall to locate the camshaft position sensor.
What happens when the camshaft position sensor goes bad?
Poor Drivability A failing camshaft position sensor begins losing its ability to quickly transfer data. Mismatched fuel delivery and ignition timing, even if off by a few milliseconds, will cause your vehicle to sputter, accelerate poorly, lack power, stall or even shut off.
Will a car start if the camshaft sensor is bad?
As a camshaft position sensor starts having problems and weakens, the transmitted signal to the car’s computer weakens as well. This means the eventually the signal is so weak that it will not allow the car to start since there will be no spark from the ignition.
Where is the crank sensor located on a Dodge Stratus?
it is located on side of engine block below starter motor.
How do I fix code P0339?
Repairs needed to fix the P0339 code vary depending on the underlying cause, but can include the following:
- Repairing or replacing damaged wiring.
- Repairing loose connections.
- Repairing oil leaks responsible for degradation of wiring.
- Replacing a failed crankshaft position sensor.
- Replacing broken reluctor rings.
Is the crankshaft position sensor the same as the camshaft position sensor?
The crankshaft position sensor monitors as a multifunctional sensor used to set ignition timing, detect engine RPM and relative engine speed. The camshaft position sensor is used to determine which cylinder is firing to synchronize the fuel injector and coil firing sequence.
Where is camshaft position sensor bank1?
Beneath the timing belt cover is where the CMP Sensor is mounted. The camshaft position sensor can be found in the right side of the engine compartment at the rear of the valve cover.
What is code P0017?
P0017 is the OBD-II generic code indicating that the crankshaft and camshaft position sensor for bank 1 exhaust camshaft do not correlate signals with each other.